为什么PUDA色母包装机在拉丝过程中会断线

为满足多种场合的需要，在使用过程中需要提取色母粒。在此过程中，可能会出现断线等异常情况。为什么是这样的:

　　1. The raw material contains water, and air bubbles are generated during the drawing of the masterbatch and the thread breaks. Therefore, the storage of materials should pay attention to waterproof, moisture-proof, ventilated, and avoid direct sunlight. Materials with high moisture content should be dried before use.

　　 2. The thermal traction ratio is inappropriate. The traction ratio is too small, the wire is not fully stretched, and the tension is small. The heat traction ratio is large, and the wire will break if it exceeds the wire limit.

　　3. The hot water tank is too short, and the silk does not reach the upper limit of the masterbatch after heat traction.

　　4. The screw speed is fast or slow, and the traction cannot automatically adjust the speed. The thickness of the wire is different, which affects the tension of the wire or breaks the wire.

　　 Therefore, we must pay attention to the above problems in the process of drawing the masterbatch to prevent the phenomenon of wire breakage. In addition, in addition to the above issues, it should be noted that the addition amount should not be too much, otherwise it will be counterproductive.

普达母粒包装机:

由于粉体的粒度、堆积密度、流动性好，建议采用自由流动包装机。我们有开袋和阀门袋包装机提供。此外，普达还拥有母粒吨袋包装机。